On 10/20/2012 2:27 PM, pltrgyst wrote:

> We should be closing in early January, so we'll see how going all
> induction works out...

I'm on the fence about induction but I won't be replacing my stove for a
long time now since I recently upgraded my kitchen, also with all GE
appliances.

I learned a hard lesson with the refrigerator, though. There are few
options for some of the narrower ones and I really wanted the french
door model with the freezer on the bottom. It turns out that it can't
easily be moved out of the kitchen. Problem, because I want to replace
the vinyl flooring. They said it can only be removed from the kitchen
to put in the floor if the doors are removed, and they won't do that.
I'm sure there are other companies that will but I haven't looked more
into it yet.

Congrats in advance on your new home!

Cheryl wrote:
>
> On 10/20/2012 2:27 PM, pltrgyst wrote:
>
> > We should be closing in early January, so we'll see how going all
> > induction works out...
>
> I'm on the fence about induction but I won't be replacing my stove for a
> long time now since I recently upgraded my kitchen, also with all GE
> appliances.
>
> I learned a hard lesson with the refrigerator, though. There are few
> options for some of the narrower ones and I really wanted the french
> door model with the freezer on the bottom. It turns out that it can't
> easily be moved out of the kitchen. Problem, because I want to replace
> the vinyl flooring. They said it can only be removed from the kitchen
> to put in the floor if the doors are removed, and they won't do that.
> I'm sure there are other companies that will but I haven't looked more
> into it yet.
>
> Congrats in advance on your new home!

Remove and reinstall the doors yourself, it takes about 5 minutes to do,
10 if there is a door water dispenser. The manual will have
instructions, but it's typically little more than a socket set required.
Normally you remove a trim piece on the top, three bolts holding the top
bracket and lift the door up and off the lower bracket, then remove the
lower bracket. If it has a door dispenser there will be a water line and
electrical connector at the bottom to disconnect first. The water line
is normally a push-in fitting where you press in a colored ring around
the tube to release it so you can pull the tube out. Very easy.

On 10/20/2012 8:40 PM, Pete C. wrote:

> Remove and reinstall the doors yourself, it takes about 5 minutes to do,
> 10 if there is a door water dispenser. The manual will have
> instructions, but it's typically little more than a socket set required.
> Normally you remove a trim piece on the top, three bolts holding the top
> bracket and lift the door up and off the lower bracket, then remove the
> lower bracket. If it has a door dispenser there will be a water line and
> electrical connector at the bottom to disconnect first. The water line
> is normally a push-in fitting where you press in a colored ring around
> the tube to release it so you can pull the tube out. Very easy.

Yes, it doesn't look very difficult to me at all. No door water
dispenser, just one inside the fridge. I'm glad I got that option
instead of on the door because my brother's new one like that has a lot
of interior space taken up on the door because of it. I like having the
space on the door shelves. Thanks for the info above!

Cheryl wrote:
> On 10/20/2012 2:27 PM, pltrgyst wrote:
>
>> We should be closing in early January, so we'll see how going all
>> induction works out...
>
> I'm on the fence about induction but I won't be replacing my stove for a
> long time now since I recently upgraded my kitchen, also with all GE
> appliances.
>
> I learned a hard lesson with the refrigerator, though. There are few
> options for some of the narrower ones and I really wanted the french
> door model with the freezer on the bottom. It turns out that it can't
> easily be moved out of the kitchen. Problem, because I want to replace
> the vinyl flooring. They said it can only be removed from the kitchen
> to put in the floor if the doors are removed, and they won't do that.
> I'm sure there are other companies that will but I haven't looked more
> into it yet.
>
> Congrats in advance on your new home!

What are your qualms re induction?

--

On 10/21/2012 12:35 PM, Jean B. wrote:
>
> What are your qualms re induction?

I guess I just don't want to have a cooktop that is persnickety about
the cookware I use. I don't know what else my thoughts about it is
other than just some complaints I've read here and elsewhere.

On 10/22/2012 2:05 PM, Cheryl wrote:
> On 10/21/2012 12:35 PM, Jean B. wrote:
>>
>> What are your qualms re induction?
>
> I guess I just don't want to have a cooktop that is persnickety about
> the cookware I use. I don't know what else my thoughts about it is
> other than just some complaints I've read here and elsewhere.

Too bad they don't make cooktops with one gas, one induction, one
halogen, and one plain old electric coil burner. Then you can figure out
which one works best for you. My induction range is OK but it would be
the cat's pajamas if it had one plain old electric coil burner.

As far as ovens go, I prefer electric or rather, I don't like gas ovens.

On 10/22/12 8:25 PM, dsi1 wrote:

> Too bad they don't make cooktops with one gas, one induction, one
> halogen, and one plain old electric coil burner. Then you can figure out
> which one works best for you. My induction range is OK but it would be
> the cat's pajamas if it had one plain old electric coil burner.

At least two companies make hybrids, combining two induction burners
with two glass halogen burners. I might have gone for one of those, but
our builder wouldn't consider those as options. 8;(

-- Larry

On 10/22/2012 3:21 PM, pltrgyst wrote:
> On 10/22/12 8:25 PM, dsi1 wrote:
>
>> Too bad they don't make cooktops with one gas, one induction, one
>> halogen, and one plain old electric coil burner. Then you can figure out
>> which one works best for you. My induction range is OK but it would be
>> the cat's pajamas if it had one plain old electric coil burner.
>
> At least two companies make hybrids, combining two induction burners
> with two glass halogen burners. I might have gone for one of those, but
> our builder wouldn't consider those as options. 8;(
>
> -- Larry

I'll bet he would have installed it if you had shown up at the site with
it in the back of your truck. Those sound like a pretty good deal.
Anyway congrats on your new kitchen.

dsi1 wrote:
> On 10/22/2012 2:05 PM, Cheryl wrote:
>> On 10/21/2012 12:35 PM, Jean B. wrote:
>>>
>>> What are your qualms re induction?
>>
>> I guess I just don't want to have a cooktop that is persnickety about
>> the cookware I use. I don't know what else my thoughts about it is
>> other than just some complaints I've read here and elsewhere.
>
> Too bad they don't make cooktops with one gas, one induction, one
> halogen, and one plain old electric coil burner. Then you can figure out
> which one works best for you. My induction range is OK but it would be
> the cat's pajamas if it had one plain old electric coil burner.
>
> As far as ovens go, I prefer electric or rather, I don't like gas ovens.

Well, my old cooktop had two induction burners and two normal
?halogen? burners. I almost always used the induction
burners--unless the size pot I was using dictated otherwise. That
cooktop, in general, sucked. It was very feeble.

--

On 10/22/2012 6:02 PM, Jean B. wrote:
>
> Well, my old cooktop had two induction burners and two normal ?halogen?
> burners. I almost always used the induction burners--unless the size
> pot I was using dictated otherwise. That cooktop, in general, sucked.
> It was very feeble.
>

I had one of those with weak burners. Beats the heck out of me why that
was. I changed the burners and then the receptacle block. It was still
the same. Big bummers.

On 10/22/12 8:05 PM, Cheryl wrote:

> I guess I just don't want to have a cooktop that is persnickety about
> the cookware I use.

All cooktops have restrictions on some types of cookware -- e.g.,
Corningware is a no-no on gas burners.

-- Larry

On 10/22/2012 9:26 PM, pltrgyst wrote:
> On 10/22/12 8:05 PM, Cheryl wrote:
>
>> I guess I just don't want to have a cooktop that is persnickety about
>> the cookware I use.
>
> All cooktops have restrictions on some types of cookware -- e.g.,
> Corningware is a no-no on gas burners.

When I updated my stove from electric coil to ceramic cooktop, I didn't
have to change the cookware I use.

I don't have the option for gas.

On Tue, 23 Oct 2012 00:27:28 -0400, Cheryl >
wrote:



>
>When I updated my stove from electric coil to ceramic cooktop, I didn't
>have to change the cookware I use.
>
>I don't have the option for gas.

Did you consider propane? I had it put in about 30 years ago.

On 10/23/2012 6:05 AM, Ed Pawlowski wrote:
> On Tue, 23 Oct 2012 00:27:28 -0400, Cheryl >
> wrote:
>
>
>
>>
>> When I updated my stove from electric coil to ceramic cooktop, I didn't
>> have to change the cookware I use.
>>
>> I don't have the option for gas.
>
> Did you consider propane? I had it put in about 30 years ago.
>
We did that a few years ago - I wish we'd done it sooner!

Looking for induction hobs or Kitchen electronic Appliance that makes your work easier through www.morefortheoutdoor.com/ Twin Eagles Gas Grills </a> tha makes you work faster and save your time and also your money.I f you looking for your Kitchen something Unique. I will suggest you to buy this online. You definately satisfied after using this.

Cheryl wrote:
> On 10/21/2012 12:35 PM, Jean B. wrote:
>>
>> What are your qualms re induction?
>
> I guess I just don't want to have a cooktop that is persnickety about
> the cookware I use. I don't know what else my thoughts about it is
> other than just some complaints I've read here and elsewhere.

What were the complaints?

--

On 10/23/2012 12:01 AM, Jean B. wrote:
> Cheryl wrote:
>> On 10/21/2012 12:35 PM, Jean B. wrote:
>>>
>>> What are your qualms re induction?
>>
>> I guess I just don't want to have a cooktop that is persnickety about
>> the cookware I use. I don't know what else my thoughts about it is
>> other than just some complaints I've read here and elsewhere.
>
> What were the complaints?
>
Boilover issues, burners going cold when lifting a pan.. those are what
I can think of off the top of my head.

On 10/23/12 12:28 AM, Cheryl wrote:

> Boilover issues, burners going cold when lifting a pan.

Boilover issues are *less* of a problem with induction in every way
imaginable, because 1) you can set almost every induction burner to a
specific temperature (e.g., just below or above boiling), 2) you can
place parchment paper between the pan and the burner, 3) cleanup is as
easy as any glass cooktop, and 4) because spilled or boiled over food
does not burn -- the burner itself gets hot (and not very hot, at that)
only from energy transferred by direct contact from the pan.

All but one induction burner I have encountered allows the pan to be
removed from the burner for at least eight seconds before the burner
shuts off.

Do you have anything else?

-- Larry

On 10/20/12 7:03 PM, Cheryl wrote:
>
> Congrats in advance on your new home!


Thanks. It should be our last home, so we're trying to make it
everything we'd like it to be.

Best of all: zero stairs!

-- Larry

On Oct 21, 9:36*am, pltrgyst > wrote:
> On 10/20/12 7:03 PM, Cheryl wrote:
>
>
>
> > Congrats in advance on your new home!
>
> Thanks. It should be our last home, so we're trying to make it
> everything we'd like it to be.
>
> Best of all: zero stairs!
>
> -- Larry

Just shows the economy might be getting better.

On 10/22/12 6:39 PM, Chemo wrote:

>> Thanks. It should be our last home, so we're trying to make it
>> everything we'd like it to be.
>>
>> Best of all: zero stairs!
>>
>> -- Larry
>
> Just shows the economy might be getting better.

We've been fortunate -- in our town, property values have not gone down
at all.

-- Larry

On 10/20/2012 6:03 PM, Cheryl wrote:

> I learned a hard lesson with the refrigerator, though. There are few
> options for some of the narrower ones and I really wanted the french
> door model with the freezer on the bottom. It turns out that it can't
> easily be moved out of the kitchen. Problem, because I want to replace
> the vinyl flooring. They said it can only be removed from the kitchen
> to put in the floor if the doors are removed, and they won't do that.
> I'm sure there are other companies that will but I haven't looked more
> into it yet.

When we moved, we hired day laborers to unload the truck for us. They
removed the doors, and we did have the ice & water dispenser in the
door. I hoped they knew what they were doing, because they did not speak
English very well. They put it back together and it worked just fine.
Good luck with your refrigerator and your new floor, Cheryl.

Becca