Mickey Zalusky wrote:
> biig wrote:
>
>>
>> Mickey Zalusky wrote:
>>
>>> biig wrote:
>>>
>>>> Has anyone used an ordinary spray bottle for this or is oil too
>>>> thick to go through the nozzle...?? TIA ..Sharon
>>>
>>>
>>> I purchased a special lab plastic bottle that is terrific for a very
>>> fine stream of oil. The nozzle doesn't clog and the wide screw-top that
>>> makes it very easy to refill as well a clean between fillings. Here's
>>> where I purchased mine from www.usplastics.com. The specific bottle
>>> purchased for around $7.00 is:
>>>
>>> http://tinyurl.com/bkwhs
>>>
>>> I was concerned about the nozzle leaking so I found a small bottle cap
>>> and keep it on the end of the nozzle to avoid any dribbles.
>>>
>>> The very narrow nozzle give me terrific control for limiting oil
>>> dispensing and, because the bottle stays upright rather than tipping it
>>> upside down to dispense, there's never a problem with oil leakingi out
>>> the cap or bottle rim.
>>>
>>> Mickey
>>
>>
>>
>>
>> Thanks Mickey and all the others for your answers. Mickey..I've been to
>> their outlet just off I75 in Ohio (is this the same one?) Sharon
>
> Sharon, I've only ordered over the phone. I live in CA.... It must be
> fun to actually see and touch all of their wonderful containers.
>
> I remembered also ordering a few "Delta Foam Dispenser" bottles that are
> great. You fill the bottle with 1/4 liquid hand soap and fill the rest
> almost to the top with water. When you push down on the pump, the soap
> dispenses in foam form. I have one at the kitchen sink and in each
> bathroom as well. Very economical and the foam is fun too!
>
> Mickey

Sharon, the company's address is

United States Plastic Corp
1390 Neubrecht Rd.
Lima, OH 45801-3196