On Sunday, June 25, 2017 at 11:24:51 PM UTC-5, sandv wrote:
> Hello! We might have the same problem. Where did you find the microswitch? Couldn't find it anywhere. Thanks so much for your detailed description.

The issue with mine turned out to be the thermal fuse, which is in the bottom part of the grinder next to the motor (remove the 4 screws in the base to access). It's a small silver cylinder with a green cap. Test it for continuity, if it fails then it needs to be replaced. It can also be bypassed (simply removed), which is what I did. Just be careful when using afterwards (wait for motor to cool down between uses), as the motor may burn out if it is run continuously for too long.